One of the best upgrades on any old Mopar is to freshen the.
THIS TOOL FACILILTATES THE REMOVAL OR INSTALLATION OF THE UPPER CONTROL ARM BUSHINGS. TO PULL AN OLD BUSHING OUT, PLACE THE CYLINDER OF THE TOOL ON THE OUTSIDE OF THE CONTROL ARM, INSERT THE THREADED ROD AND TIGHTEN IT TO EXTRACT THE BUSHING.
Long term, we really aren't sure of what direction we want to go with this fastback fish.
TO INSTALL A NEW BUSHING, PLACE THE CYLINDER OF THE TOOL ON THE INSIDE OF THE CONTROL ARM, INSERT. To remove the upper control-arm bushings, we use a 1/2-inch jackscrew as shown. The large pipe fitting to the left receives the bushing as it is pressed out, and is ground with a step to clear the flange at the edge of the control arm.
May 06, SOLD Upper Control Arm Bushing Reinforcement Rings On The Rear Bushings with Ma Mopar, thought they did some good, for what reason or another.
As you can see, i took lot's of UCA's out of cars to rebuild, recondition, back when they were find able, at the Pick-N-Pull wrecking yards. and war wounds" on them, during the removal, that. Special bolt used with 76kit for upper control arm bushing removal on AMC Eagle and Jeep Vehicles. Current Usage (TJ) - System (2 - Front Suspension) To minimize the tools necessary to service Chrysler Group vehicles, this usage information is subject to change as vehicles and components are released or updated.
Jun 04, Here is an old school method that works well in removing your old worn out lower control arm bushings in your Mopar. This is a video of replacing upper and lower control arm bushings with energy suspension polyurethane bushings. Here we replace the control arm bushings with.